Help... My Z9X Ziddo.... stop in zidoo Logo When I start .... on Zidoo Status always "Up"... then "Hello " On TV Screen onyy "Zidoo Logo" I try flashing with USB... Status Install then after 100% complete & restart...but it repeatly install again I try Push reset button & power button, nothing happen (Problem start in 27 June 2021)
Did you follow these instructions EXACTLY: https://www.zidoo.tv/Support/support_guide/guide_target/x0Yfq[ld]QEAzbeq7k9e[ld]3ulg==.html
Yes, i follow every step.... after install complete..... it repeatly install again (note : i don't press reset button)
Power off. Press Reset button and power on keeping it pressed after 5 sec you may release it. The emergency flash progress window should appear.
What's the full name of the image file you used? Was it: Z9X_P_v6.0.19_202008072201_usb-install.img or Z9X_P_v6.0.22_202008111916_usb-install.img
I try both... First time success but after a few hours, i try to restart, then zidoo come back "UP" & "Hello".... Until now (install loop)
https://www.zidoo.tv/Support/support_guide/guide_target/x0Yfq[ld]QEAzbeq7k9e[ld]3ulg==.html I take z9x flash from here
I'm confused. First you say you tried both, then you say you used the one on that link. I asked about them because there was a version of 6.0.19 that caused some issues around at one point, so 6.0.22 is the version to use. Switch the box off using the switch on the back and then follow those instructions to the letter. Make sure the USB is FAT32 Make sure the file is renamed to "install.img Make sure it is plugged into a USB3 slot on the right Make sure you hold the reset button in while switching on using the switch on the back and hold it in until you see "Installing" on the TV screen.