X20Pro : power on & power off through HTTP control

Discussion in 'ZIDOO X20 PRO' started by Fbrighi, Apr 18, 2020.

  1. Fbrighi

    Fbrighi New Member

    Hello, i'm controlling a Zidoo X20pro using network and http controls. I'm able to go from Power On status to standby with Key.Power.On.Standby string...but then it is not possible to power on it again with Key.poweron. I tried all commands and combination. Looks like network card is not active when zidoo is standby. Where i can find setting to make it active also in standby state?

    Thanks!
     
  2. myzidoo

    myzidoo Active Member Beta test group

    Doesn't work. Hardware limitation.
    Power ON from shutdown and standby only works over RS-232
     
  3. Steven Coymans

    Steven Coymans New Member

    And how about using a iTach IP2IR?
    I tried but could not getting it to work. But I'm wondering if I send the correct IR codes.
     
  4. myzidoo

    myzidoo Active Member Beta test group

Share This Page