I want to find a way to remotely shutdown or get on standby mode the Z9X I can wakeup the device from standby mode via my router but I can't find how to return in previous state.Is there a command in windows cmd to do this? I tried the command : shutdown /m \\192.168.178.28 /s /f but I get the message 192.168.178.28: Access is denied (5)
The IP protocol uses TCP/IP on port 9529 and there are standby/Off commands. These unfortunately effectively shut down the network card so the box is then unresponsive to further commands - however you can then use WOL since in standby the card reverts to 10 base-T and will respond to WOL. Protocol doc attached. The best way to control the box with full discrete on/off is with RS232, again, doc attached.
