Not working eARC connection because of Zidoo Z1000 Pro

Hi Guys,

My Z1000Pro (FW 6.3.92) is connected via HDMI to Denon AVR-X2600H amplifier and the amplifier is conected to Samsung QE55Q70RATXXH TV (both using eARC inputs).Unfortunately, when I power down Zidoo, Denon and TV and then switch on only Denon and TV (Zidoo is still powered off), eARC connection from TV to Denon doesn't work anymore (there is a message displayed on TV "eARC is not available"). What I have to do then is to cut & plug again power using rear Zidoo power switch. After that Denon-TV eARC connection is available until I switch Zidoo on and off again.
It doesn't matter neither CEC is on or off in Zidoo settings nor if Zidoo is totaly shutted off or in standby mode.

I think my problem has arisen in FW 6.3.92 becausee I didn't notice such problems in previous versions.

Coud you advise me any solution?

Where can I find previous FW (I've found only 6.3.75).

 

Just wait for the next FW. Patience is a virtue (they say ).

 

PS. FW 6.3.75 does work for me with CEC enabled.

 

You should be able to change device to which HDMI CEC will connect if you go to source selection on TV. Above icon for HDMI port connected to your AVR there should be HDMI CEC button.