Tomas ,also for me the command ESC didn't work...I have turned on the box after having started Putty(at that time it has received the log).
Hello everyone.In the log of Putty I read, a long explanation(it said to make other things) without finding the command Gore (before the failed...
I had the same problem too, the cable connectors are square instead the uart socket on the zidoo is very small. I connected two cables then the...
The zidoo is back to work. The second method suggested by Slavenzis has fixed everything. Thank you guys.
Hi I managed to access the zidoo. i followed the slavensiz isctructions,but says "factory read path noth found." I try to restart with gore but it...
I connected the cable to uart port(very difficult), I updated the cp2014 drives,after I have installed 0.70 putty software ,then I go into session...
Hi thank yuo very much zero33. I took a lens to read the writing on the zidoo, from left to right (with the usb port on top) there is 3.3v TX RX...
After two months I'm trying again the ttl uart cable has arrived, there are 6 pin(5 in the cable wingoneer cp 2014) but only 4 on zidoo x9s uart...
Thank you very much Slavensiz. Thanks for your help Sarco.I'm trying to understand...
Hi,I opened the box to see the uart port. Can you give me more specifications on the TTL cable right for connection?
The Zidoo Team should provide us with a recovery software with bootloader that can always upload, like the emergency procedure, but it does not...
Thanks Sarco,I have to get the right TTL cable and try,it seems a very complicated procedure.
@mirror I had installed the latest firmware 2.34 then five seconds of reset with the green screen appeared and a few seconds to block everything.
Thanks Sarco,(doesn't find the function @mirror). It 'the same problem of other users:it seems to load only for a few moments but then the...
Zidoo team I need assistance,please. seems like a problem with the bootloader. with the emergency procedure not loaded, the pen drive flashes for...
Separate names with a comma.
