New Z9X 8k constantly switching off with Valerion projector

Discussion in 'HDD 8K Media player(AML S928X)' started by Muggy1971, Apr 10, 2026.

  1. Muggy1971

    Muggy1971 New Member

    I didn't check the buttons on the Valerion to see if they are controlling the Zidoo. I'll check that over the weekend with I take the projector back out again for viewing. We have small kids at home so I cannot leave it out permanently. I have contacted Valerion directly and heard back from them today with some suggestions regarding switching CEC off etc. which I have already done so here's hoping they'll have a fix for it soon. Its just not the same watching movies on the 65 inch Oled when we"re used to the big screen:))
     
  2. Markswift2003

    Markswift2003 Well-Known Member SUPER Administrator Zidoo Beta Tester Contributor

    It's a bit of a long shot, but you never know.. There's no need to get the projector out, just the remote - in fact it's better not to have the projector fired up if you're testing all the remote buttons!
     
  3. Muggy1971

    Muggy1971 New Member

    I'll try that tonight. Thanks Mark
     
  4. Alex Yu

    Alex Yu New Member

    I have a Valerion Visionmaster max and UHD8000. I had that happened to me when I first had the Valerion last week. Its OK now. I switch to HDMI 2.1 RUIPRO and try different ethernet cable. I have an 14T drive networking with Zidoo. Hope that help! Before I had the UHD8000 linkup with JVC NX-5 using a HDMI 1.3, it was fine!
     
  5. Muggy1971

    Muggy1971 New Member

    I have once again switched off CEC on both machines, I’m using the Lindy CEC blocker and selected hdmi format as standard 1.4 and it played a 3 hour movie last night without rebooting. I’ll need to test it further tonight and see if continues to be stable. The fact that it’s intermittent or seems to be is the puzzling thing. I have Ray on the Valerion technical support team helping me now as it does seem that it’s a Valerion issue as mentioned by some of you. My final step will be to add a HDFury and a new HDMI 2.1 cable although the one that came supplied with the player should be as good as I need. Thanks everyone for all the suggestions.
     
  6. Muggy1971

    Muggy1971 New Member

    I have just read on another thread that people are having an issue with their machines rebooting while using 5ghz wifi. This could be my problem too as when connected to the Valerion I'm using wifi and when connected to the tv I'm using ethernet without any rebooting issues. I'll try the Zidoo with the LG Oled later on wifi and see if it's the wifi. Otherwise I'm at a total loss as to what it might be as Valerion support staff have gone through everything with me and say it's the Zidoo that seems to be the problem.
     
  7. NeoKeeLo

    NeoKeeLo New Member

    @Markswift2003 I am going to check my settings on my receiver, projector and UHD-8000 tonight and see if this is causing my Zidoo to power cycle off. Thanks!
     

Share This Page