How to connect DMP A6 with 2x F2 in a vertical mode? Like one Speaker per Amplifier with one output to upper speaker connection (treble) and one to the lower (bass).
Vertical bi-amp with such components means you need to put each F2 in bridge mode, which disables one channel input connections and half of the speakers outputs connections, and connect only one channel output of the A6 to each of the two F2. At that point, the only option you have to make use of separate HF and LF binding posts at loudspeaker level is bi-wiring them from the single couple of binding posts of the F2 to the two couple of binding posts of the loudspeaker. This last configuration is of course not an horizontal bi-amp configuration and quite questionable per se in terms of real sonic improvement (also very dependent by internal design of the speakers crossover), but the best you can implement without moving to a proper vertical+horizontal configuration which would require a total of 4 F2 amps.
Thank You for answer. This means that bi-wiring is the solution i my case since I only use one F2. 4 pcs. F2 is no option for the most of us. Then I will propose an improvement for a new version of the F2. Make a new option that allows signal on both outputs like a mono setup. This will allow bi-amp solution with separate output for bass and treble.
