USB HDD not recognized at startup

Discussion in 'ZIDOO X9S' started by jo23, Jun 25, 2017.

  1. jo23

    jo23 Member

    My 3.0 USB HDD is not mounted at startup since 1.4.6. Any hints?

    Best regards
     
  2. jo23

    jo23 Member

    It is only recognized if i disconnect the device after boot, and reconnect again.
    I tried the USB 2.0/3.0 ports and with a Y-Power cable without success, very disappointing.
     
  3. GoldBar

    GoldBar Member

    Yes, this is a bug that Zidoo hasn't fixed yet... very disappointing.
    It happens when you switch off the box through CEC. When you turn it on again it will forget the HDD connected to the USB3.0 port.
    It was ok before v1.4.6
     
  4. jo23

    jo23 Member

    This is not related to CEC, i have an adapter that disconnects the CEC pin. And i turn of and on the power supply.
     
  5. jo23

    jo23 Member

    Please Zidoo help, it worked before 1.4.6 but now i have to disconnect/connect the external HDD on every power on. :(
    Does anyone know a tool that can re-mount the device. I tried some, but without success.
     
  6. DELUCAS

    DELUCAS Well-Known Member

    My portable usb 3.0 hard drive gets seen all times by my X10

    It may not like your make of hard drive or the way as in ntfs or fat 32 etc ?
     
  7. jo23

    jo23 Member

    The device was recognized correctly every time with the previous firmware.
     
  8. GoldBar

    GoldBar Member

    It used to work properly up to v1.4.6
     

Share This Page