Hi folks , i have a situation with my X9 box , i flashed via bin and recovery mode, the update goes with a blue sccreen strangly fast , goes to 100% and then reboot, and green screen with 88:88 in the clock screen, what can i do? plz. there is a software for flash recovery and bootloader again?
i dont , i think. only boots and when try to enter in recovery green screen with 88:88 on clock, when i try to enter normal boot, black screen and "boot" on clock
Turn switch off, unplug for 10 min then try mstar.bin method. Put mstar.bin (Zidoo not pavo or other) on usb fat format, plug the unit then with holding reset turn switch on, wait a few second. You should see copy in front of unit. If this not work I have no clue.
No success man, the same , i think bootloader or recovery are screwed , the only is reflashing that , since manufacturer doesnt give that kind of files
I think I am in the same boat. Tried to flash a new bin (as suggested by Zidoo support) and now can't do anything. mstarupgrade.bin on a usb drive is just ignored. If I boot normally, I get a black screen and the word "boot" on the display. I don't see any way to get things back to normal. Any ideas???
Sadly zidoo have a poor customer service support I tried to contact them with no success what appear to you on x9 screen ,88:88?
Try [again] this: .use a USB stick with minimum 4 G capacity -FAT formated -mstarupgrade.bin on the stick -insert in the first USB 2 port,first on the left -keep press reset button,power on,wait couple seconds,release reset. -also,try with fw 1039 if you fail with mstar.bin Good luck, Regards,
download version 1.0.4.2-->>http://apidl.zidoo.tv/zidoo_x9/MstarUpgrade.rar, Unzip this rar package( MstarUpgrade.bin ), how to flash X9--->>http://blog.zidoo.tv/2015/02/how-to-flash-the-zidoo-x9-firmware/
nothing happen jamil, green screen display, and 88:88 on TV BOX display , tried many many times without success
3rd attempt to post to this forum. I am a new member and have an apparently bricked x9s. it displays the ZIDOO logo only. No idea what to do next. I have attempted to locate files that have been suggested in this forum with no luck. ANY help would be appreciated. I contacted Zidoo Customer support and they referred me to the company I purchased the unit. That is BANGGOOD. I have heard no reply from them. Again, ANY help would be greatly appreciated.
I have the same issue. Green screen.... 8888 I also have the problem on a similar same chip unit by Kaiber. Is there a way to connect a debugger to this device in order to upload a boot loader? Any guidance on how? Thanks