Hi @OlivierQC I'm fine and I hope you too I got the whole Justice League movie back so I could test this week-end if I have stuttering.
Great, thank you Choubs, for your information problems start within the first 5 minutes. This morning I tried back to the future I from Ghostshadow with the same result as Justice League. I suggested to Ghostshadow to make encodes in DTS HD and DD 5.1
There is no banding issue with Dolby Vision, in fact the VS10 engine handles chroma banding better that the Realtek one and that's pretty good on its own and will only exhibit using torture tests. If you see banding on DV sources, it's not the Zidoo that's introducing it. Review: Zidoo Z9X
Hello, How can I say that, I have never had Dune devices On the Dune website their devices seem to use an RTD1619 unlike the Zidoo with their RTD1619DR, for me they don't have the same functionality, sorry Darren but we can not compare what cannot be compared. I will say the best is the one that satisfies you in your daily use See you
Hi, @OlivierQC I have exactly the same issue as you, the image stutters when the Atmos audio track is used
Not possible. Dolby Vision with BT. 2020 is oversaturated. Especially the red proportion is too high. You can see it most of the time in the skin tones.
I installed last firmware and home theatre doesnt work properly. I reboot device and it works sometimes so I begin to watch a film. When I exit, it doesnt work again. I just see a blank screen and zidoo not responding. anyone have like this problem?
Hello moal, Great job, we are lucky that you come to the zidoo forum and that you share information about your work with us. Have a nice day
Good afternoon. I ran into an unexpected situation. After watching the movie, I turned off the Zidoo via CEC. The next day, when turning on the TV, the smart box could not boot. It received a command from the TV, it was evident by the noise of the fan for 2-3 seconds, and then ... nothing. The problem was solved by restoring the system with a recovery image. After that, I installed the latest firmware and re-configured the system. Has anyone come across a similar one? What could be causing the problem?
??? EVERY makemkv attempt works fine ONLY if you choose no atmos track as soon as its dolby vision and dolby atmos you get stuttering and audio lags after 3 -5 mins play switch audio back to 5.1 track and zero stutter or lag
I upload a video. (24sec) Profile 7 mel file. I think shutter is like this. Robin.Hood.2018.UHD.BluRay.2160p.TrueHD.Atmos.7.1.DV.HEVC.REMUX-.mkv
thats pretty bad stutter all right bigger pain is the audio for atmos usually goes out lagging by 2 3 seconds on top of the stutter
Hi, is there any way to avoid TV flickering during auto refresh and auto resolution setting process at the beginning of the movie playing? How exactly does the Frame rate pause option work? Is it possible to set the video starts to play after frame rate and resolution will be successfully set?